How to use the chisel
If we can process wood with chisel, the repertory of the work will increase,
It will improve quality.
Easy to use with a do-it-yourself carpenter, for the type of chisel and precise machining
I will show you how to use the chisel.
There are different types of chisel with different length and thickness depending on the purpose to use the same width.
The image is chisel with a width of 24 mm and chiseled from the left, chisel, middle hammering chisel, hammering chisel.
Characteristics of adding chisel
Since the chisel has a thin thickness and the angle of the blade is acute, decorative materials and ordinary
It is suitable for work processing. Also called construction chisel.
The angle of the blade is sharp and the sharpness is also sharp, but even with knots, small stones, even garbage the cutting edge
People who are not good at sharpening because they are easily chipped should be used with caution.
Characteristics of beating flea
Striking fleas are thick, long in handle, suitable for deep hole (mazzo hole) processing of wood
is. In recent years, machine processing is mainstream, so usage frequency is getting less.
Characteristics of middle chipping chisel
Middle thickness between the chisel and hammered chisel, all round with length
Because it faces, it can be conveniently used in renovation construction etc.
Minimum required chisel
DIY, even in a do-it-yourself carpenter, at the very least,
I want to align three different positions with different chisel width.
If it is 3rd place, it can be used for most machining.
A case by image
From the left, chisel with a width of
15 mm (5 min. Chisel), 24 mm (8 min chisel), 42 mm (1 ¼ quarter chisel)
How to use the chisel
Working in a settling
When digging a hole, along with an injec- tion line,
which is first called a chisel stand like A,
Lightly hit the chisel with a hammer to prevent the hole
from becoming larger than the scribe line.
If digging with chisel alone is difficult,
if you do like a picture with a drill woodworking gill
Time can be shortened and it can be digged easily.
(1) Even when processing soft wood, firstly flea stand.
(2) We will finish machining 2 to 3 mm inside
from the scribe line which made flea stand.
(3) We will finish machining up to the finishing line of the scribe line.
If you work with (1) to (3) in any case using fleas
Accurate machining becomes possible.
About plane(japanease kanna)
鉋台のセッティングとメンテナンス 1/6 （仕込み）
（Setting and maintenance of the blade platform 1/6 (preparation)）
鉋台のセッティングとメンテナンス 2/6 （裏金）
（Setting and maintenance of the blade platform 2/6 (裏金：back iron)）
鉋の利用３/３ 反り台鉋と際鉋（Use of planes：Warped planes&side planes）
南京鉋削り 1(Nanjing planing1)